3 Point Center Rectangle In Solidworks Sketching(Illustrated Expression)

In this article we state the 3 Point Center Rectangle rectangle drawing command in Solidworks. In Solidworks, there are lots of rectangle drawing methods to obtain required rectangle according to sketching. The 3 Point Center Rectangle is one of these commands in Solidworks.

You can find lots of informative articles about Solidworks in Mechanicalland to learn Solidworks completely. Visit the main page!

How To Draw Rectangles With 3 Point Center Rectangle Command In Solidworks?

Click on the 3 Point Center Rectangle command in Solidworks.

To draw rectangles with 3 Point Center Rectangle command, click on the little pop-up menu as shown by blue arrow above then click on the 3 Point Center Rectangle command as shown in blue box in Solidworks.

Select a proper plane or surface for 3 Point Center Rectangle.

After entering to the 3 Point Center Rectangle command in Solidworks, select a proper plane or feature surface to draw rectangle.

Select the center point of 3 Point Center Rectangle in Solidworks.

After entering to the command, you need to select the center point of the rectangle as shown by blue arrow above. The blue box region show your cursor location according to the first seelcted center of the rectangle in 3 Point Center Rectangle command.

Select the second point for 3 Point Center Rectangle in Solidworks.

After the selection of center point as shown by green arrow above, seelct the second point as shown by red arrow above. The relation between first selected center point and the second point will be as blue line above. The red box region shows the third point cursor location according to center point in Solidworks sketching.

Created rectangle with 3 Point Center Rectangle command in Solidworks.

The rectangle is created as above with the 3 Point Center Rectangle command.

Click on For Construction for 3 Point Center Rectangle.

If you select the ‘For Construction’ option as in red box above, the drawn geometry will be as shown by red arrow in Solidworks.

Enter the 3 Point Center Rectangle parameters manually.

Also you can enter the 3 Point Center Rectangle corner locations as X and Y manually as shown in red box above. You can enter the Center Point location of 3 Point Center Rectangle as shown in green box in Solidworks.

Drawing of rectangle in Solidworks with 3 Point Center Rectangle command is very easy like that.

Also there other kinds of Rectangle creation commands in Solidworks. To see the all of them, click on the link: All Rectangle Drawing Methods In Solidworks Sketching.

Comments


Leave a Reply

Your email address will not be published. Required fields are marked *