Drawing 2D Donut Geometries In AutoCAD(Illustrated Expression)

There is a special command in AutoCAD 2D to create simple donut geometries. In this short article, we will show you how to create 2D donut geometries with ‘Donut’ command in Autocad with a very basic example below.

How To Use ‘Donut’ Command In AutoCAD?

To enter into the ‘Donut’ command in Autocad, click on ‘Draw’ pop-up menu as shown by green arrow above then click on ‘Donut’ command as in green box.

After entering into the ‘Donut’ command in Autocad, specify inside diameter by entering a value as shown by green arrow above. Then press ‘Enter’ from your keyboard.

After pressing ‘Enter’ from your keyboard, specify outside diamete by entering a value again as shown by green arrow above in Autocad. Then press ‘ Enter’ from your keyboard again.

After pressing ‘Enter’, you can click to specify the center points of donuts respectively like above in Autocad.

Right click then exit from ‘Donut’ command if you done.

The use of ‘Donut’ command to create 2D donuts in Autocad is very simple like above. Do not forget to leave your comments or questions about ‘Donut’ command in Autocad below!