Home » All Programs » Stretch Entities Command In Solidworks Sketching(Illustrated Expression)

Stretch Entities Command In Solidworks Sketching(Illustrated Expression)

In this article we will show you how to stretch sketch entities in Solidworks with ‘Stretch Entities’ command with a very basic example above.

How To Use ‘Stretch Entities’ Command In Solidworks?

Click on ‘Stretch Entities’ command in Solidworks sketching.

To use the ‘Strecth Entities’ command in Solidworks sketching, you need to be inside an active sketch as above. For example we want to strecth the rectangle shown by green arrow above. To do this, click on little pop-up menu as shown by red arrow then click on ‘Stretch Entities’ inside green box.

Specify the required parameters for ‘Stretch Entities’ command in Solidworks.

After entering into the ‘Stretch Entities’ command, we selected the three of edges of rectangle to stretch it from red box as shown by red arrows above. We did not selected the edge that shown by blue arrow above. If we selected this edge, the whole rectangle geometry will be moved like in ‘Move Entities’ command. But in this case, the rectangle is stretched according to unselected edge.

There are two types of strecthing methods;

If you select the ‘From/To’ method as in blue box for stretching, you need to define a base point as shown by green arrow above. Then you need to move that base point with your mouse to stretch the geometry.

Enter the X and Y coordinates for ‘X/Y’ method of stretching in Solidworks.

If you select th second method of stretching ‘X/Y’ as in green box above, you need to enter the stretch distance values in X and Y coordinates respectively as shown by green arrows above in ‘Stretch Entities’ command.

To complete the stretch of the sketch entities with ‘Stretch Entities’ command, click on little green yes button at the left-top.

The use of ‘Stretch Entities’ command in Solidworks sketching to move sketches is easy like that. Leave your comments and questions below about ‘Stretch Entities’ command in Solidworks!

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *


Please

leave feedback ?

( For the post )

ASK THE MECHANICALLAND

COMMUNITY


We are always open to your feedback to improve ourselves and the quality of our content! If you have any suggestions, thoughts, or criticism, please let us know. We are trying to improve our blog with constructive feedback. We are aware of how valuable your feedback is for our future development, and we will carefully read all your comments. Thank you in advance!