This is a very useful too just as Quick Trim command in Siemens NX. You can extend the selected objects or sketch entities, to a selected entities with ‘Quick Extend’ command in Siemens NX. In here, we will explain, how to do this kind of thing with ‘Quick Extend’ command in Siemens NX, with a very basic example below.
How To Use ‘Quick Extend’ Command In Siemens NX?
To use ‘Quick Extend’ ccommand in Siemens NX, you need to open an active sketch. Or if you have a sketch entity that must be extended up to an another object, you need to enter the required sketch of that sketch entity just like above.
Click on ‘Quick Extend’ command as shown by blue arrow above. After entering into the ‘Quick Extend’ command, select the boundry object as shown by green arrow above. Selected entities will be extended up to this boundry.
Then select the entities must be extended as shown by red arrow above. All the selected entities will be extended up to selected boundry object.
As you see above, the preview of extension is shown as red color.
Also you can directly select the entites to be extended as shown by red arrow above. If you do not select an boundry object like above, the selected entities will be extended up to nearest entity as shown by green arrow above.
YOU CAN LEARN SIEMENS NX IN MECHANICAL BASE; Click And Start To Learn Siemens NX!
This is a very quick way to make extensions with ‘Quick Extend’ command in Siemens NX.
As you see above, the use of ‘Quick Extend’ command to extend sketch entities in Siemens NX is very easy like above. Do not forget to leave your comments and questions about ‘Quick Extend’ command in Siemens NX.
Your precious feedbacks are very important for us.
Leave a Reply